Category: New Hemi Swaps
PS box clearance issue
I am installing a late model 5.7 in a 73 Cuda. My setup is a QA1 k member, Hooker Blackheart engine mounts, New Hooker Blackheart low profile log exhaust manifolds, Borgeson power steering box, and a SilverSport 4L60E transmission. So far so good until…
Nag1 Starter
I have started a 71 barracuda build with a 6.4, Nag1, RMS front suspension, TTI headers. What is the benefit of putting the starter on the passengers side vs the drivers side with the Nag1 tranny?
Holley drive by wire pedal
Anyone use one of Holley’s generic drive by wire pedals in a 70 challenger? If so, how do they fit on the firewall? Pedal height the same as the other pedals? Anyone have photos? Thanks in advance!
hellcat engine swap
what would be the best choice of torque convertor ? 46rh trans behind hellcat engine street car big tire
Evaporator to compressor line routing?
How is everyone routing the evaporator line from the firewall to the compressor on the Gen3 swaps?
I’m staying with the stock evaporator, and need to get that connected to the low mount compressor up by the power steering.
Any pics and suggestions fo…
Using the factory hemi oil pan
I see there is a modification now for the factory K member to fit the factory Hemi oil pans. Has anyone had any experience with that? Could it be done to the QA1 k member? Seems like a cheaper way to install vs new pan and pickup.