Here is the problem...I can find no parts for my fury 3 as far as body parts are concerned. Brakes for example, I want to swap for disc but can find no kits or anything else for that matter.
Interior (dash, ect...) (repair parts for non-engine components)
The engine was an easy fix. It has a 340 f
I have a very nice 1957 392 hemi looking for a good home and I have found a nice 65 coronet 500 2dr hardtop looking for a nice engine to be installed in it.This engine is a high quality rebuild with tons of parts from Hemi Hotheads and could easily push 500 horse.My question is will this engine fit
On p36 Sept issue Mopar Muscle Magazine,there is a photo with two identical rockers side by side.That ain't right.The one on the right should be a mirror image of the (correct) one on left.Don't try to run this engine until this is sorted.
this poster show the first automatic transmission it has a pic of a guy in a canoe paddling in a river {ted williams ??? ] very colorful and in perfect condition it has been rolled in a tube all these years asking $ 50.00
Hello, looking for anyone who has ever installed a vinyl top on a 67-69 fastback cuda. I have a 69 cuda that didn't come with a vinyl top but would like to install one. I now have both of the trim pieces and half ( have 8 need 8 more) of the small hardware pieces. I have some great pics from the fol
Got me a 1978 Dodge Pickup
it now has 1974 body/interior i am told
The only engine details I got were
360 ci
purple cam shaft,
J heads,
Edelbrock performer intake,
holly 600 dual line carb,
Mickey thompson valve covers,
dyno max headers,
K+N filter.
new water pump,
New altenator,
+ 8mm wires.
90
When i found my '69 RT it had two 2-2.5'' wide stripes about 2.5'' apart running at the usual
angle from aft the gas cap to near the rear of the tire cutout'.
I have never before or since seen this type of stripe, the RT was set inside the stripes (or into part of the stripes and incorporating t
