Author: Racecar32
upper custom radiator support cover
Anyone ever built a custom radiator cover support for ther Challenger ? Thinking about doing something like this to mine . Anyone have pics of theirs ? Thanks
compression check 360 good or bad ?
I have a miss when I get on it from 1st to 2nd and 3rd to 4th . Timming was good and set the Elderbrock Carb with a vacuum gauge . All was good . Ran a compression check
No 1 120
3 118
5 122
The rest of the cylinders were
148 to 150 ra…
Dryer bracket
Looking for a Dryer Bracket for my 73 Challenger , anyone have one ?
Thanks
Z bar installation help
I have never worked with a z bar . I installed the motor and transmission and wondering …. Do I loosen the Zbar from the frame and pulled it back and then push it on the ball of the bellhousing or can I take the ball off the bellhousing put it in th…
Best clutch 360 small block
Getting ready to change my clutch out on my 360 . Any recommendations before I buy ? Im not planning on drag racing it… just to cruise . The motor has a slight cam with headers nothing major .
Thanks
water leak on my 360
I am pulling my 360 out of my Challenger . Ive pulled the trans. and when I did the motor drop down a bit . When that happened water began running down at the back of the motor on the left side. I have already drained the radiator .Theres no water on …
Chrome or Billet pulleys
Anyone know of a company that sells a complete pulley set for the small blocks ? Im going to add some bling to my motor this winter . March has them but their over my budget .
Thanks