Author: mbolin05

Dana 60HD narrowing for an e-body

I have a Dana 60 HD housing, and a trac lock, 30 spline, and I would like to narrow it for my barracuda. Originally it came from a 3/4 or 1 ton pickup.

I know it has to be offset side to side.

I know its a little heavier than the regular Dana 60.

Tail panel corner brackets

I forgot to include this in my previous post. Do the tail panel brackets go on the outside of the tail panel as in the pic …or so they go on the inside of the panel?

New photo by Matt B

Tail panel depth

70 barracuda tail panel…here is a video of it clamped in place. Should it set flush with the rear quarter or be set in some as in the video?

I have a 73 parts car and the tail panel on it is flush at the top and the bottom is set in about a half …

Challenger gas filler sheet metal

I am wanting to do a side fill conversion on my frankencuda and I am looking for the gas cap sheet metal from the quarter panel . Does anyone have a junk quarter they can cut that portion off of and ship?

Thanks

Lower left door hinge

I need a factory lower left door hinge. I purchased an aftermarket hinge and my door now sets out too far…even after adjusting. I don’t believe the cheap chinese hinges are accurate. Let me know if you have one. Thanks!

Door not fully latching

I am installing my door today. I replaced the bushings in the hinges and the striker is new. I have the door and striker adjusted about where I want them but the door doesn’t fully latch when I close it. It’s just a shell no molding trim or glass. He…

1971 rear bumper urethane filler?

I have two cars..both are 73’s. One of them I am installing a 71 tail panel and bumper in and I have a question. On the 73’s there is a urethane trim panel that fits up under the rear quarter corners, and across the top of the rear bumper, covering …