i bought a used 2008 ram 4x4 four door with 5.7 Hemi. i want to change oil does anyone knows oil capacity? i think its 6 or 7 quarts.

i want to check and see if pinion angle is right on my 65 coronet. street car. 4 speed 8 3/4 posi 3.23 gear. i have never done this any tips or tricks to help me out.here are a few questions i have.where do you put angle finder? what should angle be? if angle is off you install shims under leaf spring perches? shims are tapered?

i have a 65 coronet. and i ordered pitman arm from mancini and it doesnt fit. my old pitman arm measures 10.125. the one they sent me is like 10.040. when i talked to Wes at mancini he told me that my power steering gear box shaft was a bastard size. and that they dont make a pitman arm with that 10.125 I.D. is that true?

i have a 65 coronet and i am installing all new steering components. upper and lower ball joints, tie rods , pitman arm idler arm and all new bushings. i have to remove torsion bars to do bushings in lower control arm so while they are out i am wondering if i should replace them. but i dont know how to tell if they need replacing. the torsion bars are origanal and my car used to have a small block in it. now has a big block so i was thinking i should upgrade to bigger t-bars. is there anything i can check to see if they need to be replaced. or should i just replace them because they are 45 years old. hate to have one break going 70 mph

Has anyone ever had trouble with oil leaking on big block oil pump? the oil pump on my block has a small drip on the back of the oil pump where there is a 15/16 (hex head )bolt with a spring behind it. this is a melling high volume pump. there is a plastic washer around the head of bolt that looks in good condition. i have tried teflon tape on the threads and that didnt work. also i just tried ARP teflon paste and hoping that will work. it is not a bad leak but is still annoying. not sure if a new washer would fix problem. any suggestions?

over the winter i went through my rear end and axles. i asked for advice on this web site and just wanted to thank everybody for there knowledge and advice and help on my questions. so i figured i would let everybody know the results. just to recap i installed new bearings and seals in rearend i was going to replace the ring and pinion gears but they were in good shape. this was the first time i ever set up a rear end, and it wasnt that bad. i have a 489 case posi with 3.23 gears. i also replaced axle bearings and seals. took the car out yesterday and it was good. again thanx guys :) and get ready for front end questions :D

can anybody tell me how to post you tube video on my signature for this site. i have a 42 second video of nice burnout i would like to share.