Author: jujuka

wheelhouse supports

I need these support pieces but can’t seem to find them, about all I’m lacking on my sheet metal repair. Are they available?

thanks in advance

70 barracuda Bumper bracket color

Man I’ve looked at a lot of these over the last couple weeks and seen some painted the same as the car and I’ve seen them black. My 70 challenger I painted them the same as the car.
What is the factory color?

70 barracuda tail panel

So I’m doing some pre body work intell on my 70 plymouth barracuda while its getting the rust and paint removed. I have searched around on the internet but can’t come up with the configuration that probably came with the car when new. Am I on the right…

70 barracuda convert back to the future

Ok, I’m not big on pictures of my restorations or documenting anything I’ve done to a car except for a long list of parts, prices and places I got them on an excel sheet.
But on this car, I’m going to make an exception. It’s my forth e body convertible…

Best sheet metal replacements

Ok guys, my next convertible project arrived last night and I spent the day figuring out what needs to be replaced. Pretty much the normal stuff, front inner fenders, 1 full quarter panel, floor pans, header panel and probably new valance’s. I will be …

Interior Convertible pillar trim

I need the right or passenger side trim. It clips on to the pillar and buts the dash pad on the bottom and buries in the right angle metal trim piece on the top.
I don’t see any after market convertible pieces. I see the hardtop versions but I think t…

visor pins

These are the 2 end shafts that the rubber tip slides on to on the end of the visor and clips into the rear view mirror. I think about 3" long and have a taper on one end and a groove on the other end.

thanks!