Author: HWYCRZR

I have a family member passing through that had some car issues (lost a wheel). I think we have it covered, but in case we run into any other issues the lay of the lab may be helpful. They are Ok but a little shaken. The tow truck driver and the owner…

I decided to start a new thread going through my fuel sender calibration instead of cluttering up the fuel sender rebuild thread. Fuel Sender Rebuild

It started with my repro sender would never get quite to full. 3/4 was about max. When I was browsin…

Looking to do some straight cuts in sheet metal and wondering if the sheet metal experienced have any suggestions?

Looking to cut a range between 16 and 22 gauge with minimal distortion.
I have seen 12 and 30” metal shears for straight cuts, throat…

I see a lot of C-body cruises planned in the Chicagoland area, and out east. I would love to attend these but Chicago area is 8 hours away. Are there any members in the North Dakota, Minnesota, South Dakota, Manitoba area, that would like to find a mee…

I picked up a couple of Allen engine analyzers from @Polara_500. They were taking up space in his garage and I thought I needed a new project. I am not sure yet who the winner is.
They are now taking up space in my garage. My desire is to clean them …

Went over to the Moorhead Cruise night to meet up with @Polara_500 ’s son to pick up the seat belt winders he graciously got for me. (Thanks again)
There were a few Mopar’s and a couple of beautiful Chargers for sale, and a guy that was telling me abou…

What type of tool do I need to re create the rubber hose barb on a steel fuel line?
I do searches but most cover the double flair secured with a threaded fitting.

This is what I want to re-create.

This ki…