Author: emmd61

Thinking to restore a 1960 Imperial coupe. It has some rust passenger quarter panel up to about 6 inches. I think 1960-63 would work. Source would be appreciated. Car is loaded to the max worth restoring. Arthur in NC

I have a cruise control set up I am going to install in my 62. I see in manual the dial cruise adjuster goes next to ignition switch. Where do I then relocate the power antenna switch? How do I locate the cruise brackets on inner fender well? In my …

I am likely going to buy a 1960 imperial to restore. Bottom 6 inches of behind the rear wheel quarters are rusty. Is that area the same on 60 as 61-63?

Installed trunk release in my 62 but not sure what amp fuse I should use. I bought the trunk release setup from a parts yard many years ago. I was going to hook power up to accessory slot on fuse box but not sure of amperage of fuse to use.

…

I have a nice 62 coupe and several cruise setups. I have multiple mounting brackets and not sure which is for 62. Also, several control units. Any advice how to install and which brackets appreciated. 919-630-0158

…

I have a 65 NYer wagon. The dash switch raises and lowers tail gate window fine. Key at rear tail gate only lowers. Is that standard or should I look to replace the switch? Thanks. Also…….how do I remove the glass pane to get to the rear of the swi…

I bought this options 25 years ago when I had a 63 Lebaron. I was then going to use it on a 61 or 62 project. I decided to sell it since not got around to using it. I hooked it to power and it works very well. It appears complete right down to mounting…